Ten-Haaft Oyster TV 19" Operator's Manual page 7

2. CONTROL ELEMENTS
COMMON INTERFACE (CI+) SLOT
The CI+ slot holds a Conditional Access Module (CAM) with a SmartCard, allowing you to watch programmes
and use offerings provided by pay-TV stations. Contact your provider for more information about agreements
and modules.
Note: Conditional Access Module and SmartCards are available separately.
Caution! Switch your TV set off before inserting a module into the CI+ module slot.
The CI+ module slot is located on the rear of your device. Push the CA module correctly into the slot and then
insert the SmartCard into the CA module.
• Wait some minutes for the SmartCard to activate.
• Select the channel to be used with your SmartCard.
• The details of your SmartCard are shown.
• Press to open the SmartCard menu. Observe the instructions for manual settings supplied with your CI+
OK
module.
• If the module is removed, the following message displays: "CI module removed"
• Switch the TV set on and select input signal "Digital TV".
• When the CA module is detected, the following message displays: "CI module identified"
12
2. CONTROL ELEMENTS
SIGNAL INPUTS
HDMI / AV Setup
The menus for HDMI or AV connections are similar to those of the standard TV reception, with the exception that
you cannot change the channel settings.
If there is no signal when HDMI is selected as input source, the following screen is shown:
If no signal is found within 30 minutes, the system automatically switches into standby mode.
AUDIO INPUT
Select AV as input if you wish to use e.g. an MP3 player. The display will switch off after 30 minutes while the
speakers remain active.
13