Ten-Haaft Oyster TV 19" Operator's Manual page 13

3. OPERATING THE "OYSTER® TV"
Press to add symbol rate, frequency and polarity.
RED
Press to save your settings.
OK
Press to start scanning the new transponder. All new channels are added to the end of the channel list.
BLUE
24
3. OPERATING THE "OYSTER® TV"
TROUBLESHOOTING SATELLITE SETUP (DVB-S)
1. No channels were found, and the signal and quality display showed only small or no values at all.
Check all cables between TV and LNB. Make sure that the antenna is aimed at the right satellite and that the
view is not obstructed by trees or other obstacles.
2. Not all or the wrong channels were found during the search.
Make sure that the antenna is aimed at the correct satellite and that this satellite is set up in the menu.
3. Block-shaped image distortion or audio dropouts during playback.
Check the "Channel" menu for signal loss and quality. Even a minor antenna misalignment can cause a major
loss of reception performance. Mind that the cable should not be too long. Note that different satellites may
require an antenna of different size.
4. Signal loss at light rain or snow.
This issue is usually caused by an insufficient signal. Check the aiming of the antenna and its size.
5. Signal is lost during windy periods.
Check the antenna for secure attachment. It should not move. Make sure that no obstacles such as trees
obstruct the antenna's view.
6. Subtitle and audio track are in the wrong language.
Check the language settings in the menu.
7. Adding a new channel that is not found via the scan
You need to add a new transponder. Observe the information in the corresponding part of this manual.
25