Chapter 1: Installation Of The Cooker; Connecting To The Power Supply System - Kernau KFC 90093.1 GE CI X Operation Manual

CHAPTER 1: INSTALLATION OF THE COOKER

CONNECTING TO THE POWER SUPPLY SYSTEM

• This cooker is adapted to be supplied from one-phase installation 230V ~50-
60Hz (fuse 32A) or triple-phase 3x 230V/400V/ ~50-60Hz (fuses 16A). Input
voltage of heating elements is 230V. If the electric installation in building is not
comprahensive with these parameters, qualified technician should adapted it.
• The electrical installation in the building must be equipped with a connection
socket with a pin and an effective grounding or protection system that meets the
requirements of current regulations and standards.
• If the connection socket does not apply to these standards, the proper socket should
be installed by a qualified electrician.
• The manufacturer is not responsible for the damage resulting from incorrect use of
appliance and connecting into the power supply system without proper grounding
system or protective circuit.
• The power cable should not touch the hot elements of appliance.
• The connection of the cooker should be done in that way which allows easy
access to cut the power supply system in case of failure. The distance between the
working contacts of the switch should be at least 3 mm.
ATTENTION:
The connection to power supply system can be conducted only by the qualified technician.
It is forbiden to make any changes to the electrical installation yourself.
EN
30