Advertisement
Secure the flyer unit to the top
rail with 2 screws. These will
be tightened shortly. Move the
flyer unit until the wheel and
flyer are aligned as pictured.
Then tighten the screws and
position the drawing pin
directly beneath the drive
band adjusting knob
to prevent it marking
the wood.
2
x
Tie the threading hook to the
front maid upright with tape.
Check the end of the
adjusting knob is not
protruding beneath the
maiden bar. Then place
the drive belt around
the wheel and large flyer
pulley.
Tie drive belt and cut off
the extra. Tap the steel
lazy kate pins into the
base.
1
x
12
Advertisement
