Kia Cerato 2019 Owner's Manual page 420

What to do in an emergency
4) Check if following message appears
on the cluster (if equipped).
❈ If the warning light does not blink
or the message does not pop up,
perform the process again from 2).
7 10
For recommended tyre pressure of
this vehicle, refer to chapter 9 "Tyre
and wheels " or the tyre pressure label
on the driver's door.
For proper function of the TPMS, the
driver must set the system in follow-
ing situations.
❈ Situation requiring TPMS setting
• If the tyre or wheel is repaired or
OBD068031R
replaced
• If the tyre or wheel is repositioned.
• If the tyre pressure is adjusted.
• If the low pressure light is illuminat-
ed.
• If suspension or ABS has been
replaced.
CAUTION
If the system is set without
adjusting tyre pressure, false
alarm could occur or the telltale
will not be displayed even
though the vehicle is signifi-
cantly under-inflated.
Make sure all tyres are properly
adjusted to the recommended
pressure when setting.
If the system is not set even in
required situations, false alarm
could occur or the telltale will
not be displayed even though
the vehicle is significantly
under-inflated.
The system will not be set if you
press the SET switch (2) whilst
driving. Make sure to stop the
vehicle and press the switch (2)
for over 3 seconds.
• Be sure the tyre is cold before
inflating the pressure.
A cold tyre means the vehicle
has been sitting for 3 hours or
driven within 1.6 km (1 mile).