Save These Instructions; Introduction; Customer Responsibilities; Installer Responsibilities - Briggs & Stratton 40221 Installation, Start-Up And Operator's Manual

SAVE THESE
INSTRUCTIONS
This manual contains important instructions that should be
followed during installation and maintenance of the
generator and battery.

INTRODUCTION

Thank you for your purchase of a Briggs & Stratton Home
Generator System.This product is intended for use as an
optional standby system which provides an alternate source
of electric power and to serve loads such as heating,
refrigeration systems, and communication systems that, when
stopped during any power outage, could cause discomfort or
the like.This product DOES NOT qualify for emergency
standby as defined by NFPA 70 (NEC).
This manual is an important document and should be
retained by the owner after installation has been completed.
This manual contains installation, startup and adjustment
instructions for a Home Generator System that supplies
120/240 Volt, single phase, 60Hz devices.The Home
Generator System may be operated on LP or natural gas fuel.
Every effort has been made to ensure that the information in
this manual is both accurate and current. However, the
manufacturer reserves the right to change, alter or otherwise
improve the generator at any time without prior notice.
Briggs and Stratton has made every effort to provide for a
safe, streamlined and cost-effective installation. Because
each installation is unique, it is impossible to know of and
advise the trade of all conceivable procedures and methods
by which installation might be achieved. Neither could we
know of possible hazards and/or the results of each
method or procedure. For these reasons,
Only current licensed electrical and plumbing
contractors should attempt Home Generator
System installations. Installations must strictly
comply with all applicable codes, industry
standards and regulations.
CUSTOMER
RESPONSIBILITIES
• Read and follow the instructions given in this manual,
especially the section regarding selecting essential circuits.
INSTALLATION
• Follow a regular schedule in maintaining, caring for and
using your Home Generator System, as specified in this
manual.
INSTALLER
RESPONSIBILITIES
• Read and observe the safety rules.
• Read and follow the instructions given in this manual.
IMPORTANT: If operating the generator below 40°F,
it is recommended that a battery warmer be
installed. If operating the generator below 32°F, a
battery warmer MUST be installed. This item is
available at your local servicing dealer.
INSTALLATION
ASSISTANCE

For the Home Owner:

To help you make informed choices and communicate
effectively with your installation contractor(s),
Owner Orientation Section of this manual
BEFORE contracting or starting
your Home Generator System installation.
To arrange for proper installation, contact the store at
which you purchased your Briggs & Stratton Home
Generator System, your dealer, a licensed electrician or
your utility power provider.
The Home Generator System Warranty is VOID
unless the generator is installed by licensed
electrical and plumbing professionals.

For the Installing Dealer/Contractor:

For most applications, this manual contains all the
information required to properly install and start the
Home Generator System.This manual also describes
essential circuit selection, routine operation and owner
maintenance procedures.
If you need more information, call 1-800-743-4115,
between 8:00 AM and 5:00 PM CT.
The Emission Control System for this generator is
warranted for standards set by the U.S. Environmental
Protection Agency and by the California Air Resources
Board (CARB).
5
Read and understand the