Electrolux ESF8730ROX User Manual page 11

How to set the water softener
level
Make sure the appliance is un user
mode.
1. Press .
• The indicators
and are off.
• The indicator
• The display shows the current
setting: e.g.
2. Press repeatedly to change the
setting.
3. Press the on/off button to confirm the
setting.
6.3 The rinse aid empty
notification
The rinse aid helps to dry the dishes
without streaks and stains. It is
automatically released during the hot
rinse phase.
When the rinse aid chamber is empty,
the rinse aid indicator is turned on
notifying to refill rinse aid. If the drying
results are satisfactory while using multi-
tablets only, it is possible to deactivate
the notification for refilling rinse aid.
However, for best drying performance,
always use rinse aid.
If standard detergent or multi-tablets
without rinse aid are used, activate the
notification to keep the rinse aid refill
indicator active.
How to deactivate the rinse aid
empty notification
Make sure the appliance is in user mode.
1. Press .
• The indicators
and are off.
• The indicator
• The display shows the current
setting.
– = the rinse aid empty
notification is deactivated.
, , ,
still flashes.
= level 5.
, , ,
still flashes.
– = the rinse aid empty
notification is activated.
2. Press to change the setting.
3. Press on/off to confirm the setting.
6.4 The rinse aid level
It is possible to set the released quantity
of rinse aid between level 1 (minimum
quantity) and level 6 (maximum quantity).
Level 0 deactivates the rinse aid
dispenser and no rinse aid is released.
Factory setting: level 4.
How to set the rinse aid level
Make sure the appliance is in user mode.
1. Press .
• The indicators
and are off.
• The indicator
• The display shows the current
setting: e.g.
– The levels of rinse aid range
from 0A to 6A where 0A
means no rinse aid is used.
2. Press repeatedly to change the
setting.
3. Press on/off to confirm the setting.
6.5 Acoustic signals
Acoustic signals sound when a
malfunction of the appliance occurs. It is
not possible to deactivate these acoustic
signals.
There is also an acoustic signal that
sounds when the programme is
completed. By default this acoustic signal
is deactivated but it is possible to
activate it.
How to activate the acoustic
signal for the end of
programme
Make sure the appliance is in user mode.
1. Press .
ENGLISH 11
, , ,
still flashes.
= level 4.