Table of Contents
Advertisement
5.2
INSPECTIoN ProCEDUrES: Inspect this product per the procedures listed in the "Inspection and Maintenance Log".
Documentation of each inspection should be maintained by the owner of this equipment. An inspection and maintenance
log should be placed near the product or be otherwise easily accessible to users. It is recommended that the product is
marked with the date of next or last inspection.
;
Alternative inspection criteria may be set by the owner of this equipment. Alternative criteria must be equal to or
exceed those established by 3M in the "Inspection and Maintenance Log" and other offi cial documents.
5.3
DEFECTS: If the Concrete Bolt Anchor cannot be returned to service because of an existing defect or unsafe condition, or
because it has been subjected to a fall arrest, either destroy the product or contact 3M regarding possible replacement or
repair.
5.4
ProDUCT LIFE: The functional life of the Concrete Bolt Anchor is determined by work conditions and maintenance. As
long as the product passes inspection criteria, it may remain in service.
6.0
MAINTENANCE, SERVICE, and STORAGE
;
Equipment that is in need of maintenance or scheduled for maintenance should be tagged "DO NOT USE". These
equipment tags should not be removed until maintenance is performed.
6.1
CLEANING: Periodically clean the Concrete Bolt Anchor's metal components with a soft brush, warm water, and a mild
soap solution. Ensure parts are thoroughly rinsed with clean water.
6.2
SErVICE: Only 3M or parties authorized in writing by 3M may make repairs to this equipment.
6.3
STorAGE AND TrANSPorT: When not in use, store and transport the Concrete Bolt Anchor and associated Fall
Protection equipment in a cool, dry, clean environment out of direct sunlight. Avoid areas where chemical vapors may
exist. Thoroughly inspect components after extended storage.
7.0
LABELS and MARKINGS
7.1
LABELS: Figure 11 illustrates labels on the Concrete Bolt Anchor. Labels must be replaced if they are not present or fully
legible. Information provided on each label is as follows:
1) Company Website
2) Product Specifications
3) Manufactured (Year/Month) and Lot Number
A
4) Model Number
5) Applicable Standards
6) Warning Statement
1) Materials
2) Capacity
3) Manufactured (Year/Month) and Lot Number
B
4) Model Number
5) Applicable Standards
6) Warning Statement
1) Installation Procedure
C
2) Concrete Hole Specifications
3) Inspection Procedure
1) Installation Procedure
D
2) Concrete Hole Specifications
3) Inspection Procedure
10
Advertisement
Table of Contents
