Humanware Victor Reader Classic + User Manual page 6

Back to Table of contents.
1.2. To insert and play a new book
1. Turn on Victor Reader by pressing and holding the power key, which is
located above the eject key on the front of the unit. You'll hear a beep and a
Welcome message.
2. A CD containing a book is usually stored in a plastic case. Open the plastic
case and remove the CD without touching the faces of the CD.
3. Insert your CD in the slot, which is located on the bottom side of the unit.
Gently push the CD forward. The drive mechanism will take over and
automatically finish inserting the CD. After a few seconds, Victor Reader will
announce the title of the book. If you accidentally insert a CD upside down, it
will eject automatically within 15 seconds without damage.
4. You can adjust the Tone, Volume, and Speed by pressing the up or down
buttons. The Tone, Volume and Speed controls are located on the top centre
of the front from left to right.
To move back or forward at high speed in the book, press and hold the
Rewind or Fast-Forward key until you reach the desired spot, then release it.
You'll then automatically return to normal play speed.
Back to Table of contents.
1.3. To pause a reading session
1. Simply press the Play/Stop key.
2. To resume reading where you left off, press the Play/Stop key again. Note
that if your unit is not connected to a power outlet, and if it stays in pause
mode for more than 30 minutes, it will shut off automatically to save
batteries.
Back to Table of contents.
1.4. To end a reading session
To end a reading session, simply turn the unit off by pressing and holding the
power key. You will hear two beeps. Victor Reader will automatically
remember where you left off in the book for your next reading session.
Back to Table of contents.
1.5. To start a new reading session
To start a new reading session in the same book, turn on your Victor Reader
by pressing the power key. You will hear a welcome message and after a brief
delay, you will hear the title of the book. Press the play key and Victor Reader
will start reading where you left off in your last reading session.
Back to Table of contents.
1.6. To eject a CD
To eject a CD, simply press the eject key. Victor Reader will say Eject and