Advertisement
Configuration with GoodWe Inverter
1. If there is only one BAT, DIP switch of BAT should be set as below:
2. If there are two or more than two BAT, DIP switch of BAT should
be set as below:
If there are two or more than two BAT, after connecting the
power cables, please refer to the following steps:
Only connect the communication cable between batteries at the
first, and turn on the batteries.
Wait until batteries get to work mode (The green light flashes
every 10 seconds) and then connect the communication cable
between BAT and INV.
Configuration with Inverter
GoodWe SBP /AlphaESS SMILE 5 series
The communication cable between INV and BAT is regular net cable.
1. If there is only one BAT, DIP switch of BAT should be set as below:
2. If there are two or more than two BAT, DIP switch of BAT should
be set as below:
Advertisement
