Electrical Connection; Mounting Procedure - GE GEP User Manual

4. To guarantee the enough space for heat dissipation and facilitate the installation and removal,
the spacing around the inverter should meet the requirements as demonstrated in the following
illustration.
300mm
200mm 200mm
500mm

4.2.2 Mounting procedure

1. Use the wall-mount bracket as a template and drill holes with 10mm in diameter and 80 mm in
depth on the wall.
2. Fix the wall-mount bracket on the wall with the expansion bolts in the accessories bag.
3. Hold the inverter by the side groove.
4. Mount the inverter onto the wall-mount bracket.
20mm
85mm
170mm
07
Upward -------------- 300mm
300mm Downward ---------- 500mm
Front ----------------- 300mm
Both sides ---------- 200mm
Mounting Bracket Expansion Pipe
Self-tapping Screws

4.3 Electrical Connection

4.3.1 AC Side Connection
1. When connecting the inverter, please make sure both the voltage and the frequencey of the
inverter installed are complied with grid regulations and the
2. Add a breaker or fuse to the AC side. Please note that the specification should be more than 1.25
times the rated AC output current.
3. The PE wire of the inverter should be connected to earth. Make sure the impedance of neutral
wire and earth wire is less than 10Ω.
4. Disconnect the breaker or fuse between the inverter and the utility.
5. The AC connector brand compatible with the inverters is Exceedconn.
6. When laying the AC Wire make sure that the protective earthing conductor is not strained.
The Actual AC Connector is shown in the accessory box.
Exceedconn
Exceedconn connectors installation instruction
When unplugging the AC terminals, press the
button and hold it to unlock
Torque 0.7~0.9N.m
Make sure the terminal is rotated to the lock position before the inverter is powered on.
inverter's specification.
7-9mm
unlock
PE Wire
lock
L Wire
N Wire
08