Cleaning The Fuel Sludge Filter; Checking, Tensioning, Changing The V-Belt - Bomag BPR 25/32 Operating Instructions Manual

4.14 Cleaning the fuel sludge fil-
ter
Danger
Ä
Fire hazard!
Gasoline is easily inflammable, do not spill any
gasoline.
When working on the fuel system do not use
open fire, do not smoke.
Fig. 37
Close the fuel cock, unscrew fuel sludge filter
1 (Fig. 37) and wash it out with gasoline.
Check the O-ring for damage, if necessary use
a new one.
Turn the fuel sludge filter in tightly and mind
the O-ring (2).
BPR 25/32 - BPR 25/40
ÃHhv‡rhprÃr‰r…’Ã%À‚‡u†
4.15 Checking, tensioning,
changing the V-belt
Checking the V-belt
Fig. 38
Remove the V-belt guard.
Check condition and tension of V-belt (Fig.
38).
Compression measurement approx. 5 mm.
Change a damaged V-belt.
Tensioning the V-belt
Fig. 39
Loosen the fastening screws 2 (Fig. 39) on the
V-belt side first.
Pull the engine carrier plate (1) up and tighten
the fastening screws.
Loosen the fastening screws on the starter
side.
7PH6 B
37