Trobleshooting - Termozeta Airzeta Clima C7 Instruction Manual

Do not repair or disassemble the air conditioning by yourself. Unqualified repair will lead to failure of the
warranty card, and may cause damage to users or their properties.
Problems Reasons
There is no electricity.
The overflow indicator displays "FL".
The ambient temperature is too low or too
high
The air conditioning
In cooling mode, the room temperature is
does not work.
lower than the set temperature; in heating
mode, the room temperature is higher than
the set temperature.
In dehumidification mode, the ambient
temperature is low.
There is direct sunlight.
Doors or windows are open; there are a lot of
people; or in cooling mode, there are other
The cooling effect is
sources of heat.
not good
The filter screen is dirty.
The air inlet or outlet is blocked.
The air conditioning is not placed on a flat
Big Noise
surface.
compressor does not
Overheat protection starts.
work.
The distance between the unit and the
remote control is too far.
The remote control
The remote control is not aligned with the
does not work.
direction of the remote-control receiver.
Batteries are dead.
Displays 'E2'.
The pipe temperature sensor is abnormal.
Displays 'E1'
The room temperature sensor is abnormal.
Note: If problems not listed in the table occur or recommended solutions do not work, contact the
professional service organization.

TROBLESHOOTING

Solutions
Turn it on after connecting it to a socket with
electricity.
Discharge the water inside.
Recommend to use the unit in a temperature
of 7-35 ℃ (44-95 ℉).
Change the set temperature.
The unit is placed in a room with an ambient
temperature of greater than 17 ℃ (62 ℉).
Pull the Curtain.
Close doors and windows, and add new air
conditioning.
Clean or replace the filter screen.
Clear obstructions.
Put the unit on a flat and hard place (to
reduce noise).
Wait for 3 minutes until the temperature is
lowered, and then restart the unit.
Let the remote control get close to the unit,
and make sure that the remote control
directly faces to the direction of the
remote-control receiver.
Replace batteries.
Check the pipe temperature sensor and
related circuitry.
Check the room temperature sensor and
related circuitry.
22