General Maintenance - Flexlite FLX6SB User Manual

MAINTENANCE
WARNING:
When servicing use only identical FLEXLITE
replacement parts. Use of any other parts may
create a hazard or cause product damage.
WARNING:
Always wear safety goggles or safety glasses
with side shields when using compressed air to
clean work lights. If operation is dusty, also
wear a dust mask.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts.
Most plastics are susceptible to damage from
various types of commercial solvents and may be
damaged by their use. Use clean cloths to remove
dirt, dust, oil, grease, etc.
FAN AND /OR HEATSINK MAINTENANCE
 These FLEXLITE are made with an integrate
cooling fan. Designed to resist rain and dust. This
fan and air flow heat sink must be clean frequently
to perform. Use only a low air pressure gun to
clean and remove any dust. Don't use solvent,
soap or cleaner. The unit is clean when you can
see across the heat sink.
WARNING:
Do not immerse in water.
WARNING:
Do not at any time let brake fluids, gasoline,
petroleum-based products, penetrating oils, etc.,
come in contact with plastic parts. Chemicals
can damage, weaken or destroy plastic which
may result in serious personal injury.
BATTERIES
This work light is equipped with Li-Ion Polymer
rechargeable batteries. Length of service from each
charging will depend on the type of work you are doing.
The batteries in the housing have been designed to
provide maximum trouble-free life. However, like all
batteries, they will eventually wear out. Do not
disassemble housing and attempt to replace the batteries.
Handling of these batteries, especially when wearing
rings and jewelry, could result in a serious burn.
Battery Life: Batteries that lose 20% of their capacity
must be removed from service and disposed of properly.
Return FLEXLITE to your servicing center to replace the
battery.
7