Table of Contents
Advertisement
6.
Slide the clock down over the screw heads to latch it into place.
7.
If the Automatic Self Initialization was not completed at the clock mounting location, verify the clock is receiving a
signal from the Transmitter. Remove the clock and press and IMMEDIATELY release the button located on the back
of the clock.
NOTE
When a clock is being installed or its transmission signal is being tested, it's very important not to hold
the button down too long or the hands will proceed to the 12 o'clock position and remain there
indefinitely. To release the hands from an indefinite position, press and release the button again. The
clock will automatically initiate the Self Initialization procedure and set itself.
The clock scans all channels looking for a Transmitter signal.
• Once the clock finds a channel with a Transmitter signal, the clock emits a series of beeps. Each time a valid time
signal is received the clock emits a beep, which should be once per second and continue for one minute.
• If the clock is in a marginal signal area, it emits a beep once every few seconds. Battery operated models work in
marginal signal areas, but may result in reduced battery life.
• No beeping indicates a signal is not received.
Page 10
Advertisement
Table of Contents
