Table of Contents
Advertisement
NOTE
It may require some force to remove the top clock because, in addition to the screws, the clocks are
also held in place by magnets.
3.
Set each clock using method detailed on the setup instruction sticker on the back of each clock.
4.
Once the clocks are set (with batteries inserted), orient the clock face so that the 12 is in the correct position for
your mounting option.
NOTE
Clocks are shipped in correct position for wall mounting. If ceiling mount is required, both clocks
must be removed and rotated within the bracket.
5.
Align one of the posts on the back of the clock with the appropriate post in the bracket, next to a clip. Make sure
that the raised portion of the clip next to the post is inside the bracket.
6.
Lower the clock down on the bracket, keeping all clips inside ring. Press down to seat the clock in bracket. Secure
with the two screws removed previously, in same holes in bracket (over screws holding other clock in place.)
7.
If necessary, use the four additional screws included in the package to cosmetically plug holes in bracket.
8.
Check to make sure that the 12 o'clock position is oriented to read correctly from both sides of the clock.
9.
Taking the fully assembled dual clock, line up the base (stem) of the clock with the plate that is mounted on the
wall. Slip the keyhole slots on the back of the base over the posts on the plate and push the clock down to secure.
Page 17
Advertisement
Table of Contents
