Briggs & Stratton 204730GS Operator's Manual page 12

A
B
C
D
E
A - Oil Fill Cap — Fill engine with oil here.
B - Oil Dipstick — Check engine oil here.
C - Fuel Valve — Used to turn fuel supply on and off to
engine.
D - Oil Drain Plug — Drain engine oil here.
E - Hour Meter — Displays and records how many hours
your generator has run (up to 9,999.9).
F - Grounding Fastener — Consult your local agency having
jurisdiction for grounding requirements in your area.
G - Data Tag — Provides model and serial number of
generator. Please have these readily available if calling
for assistance.
H - GFCI Circuit Breaker — A GFCI circuit breaker is
provided to protect against electrical ground fault and
protect the generator against electrical overload.
J - 120/240 Volt AC, 50 Amp Receptacle — May be used to
supply electrical power for the operation of 120 and/or
240 Volt AC, 50 Amp, single phase, 60 Hz electrical
loads.
K - 120/240 Volt AC, 30 Amp Locking Receptacle — May
be used to supply electrical power for the operation of
120 and/or 240 Volt AC, 30 Amp, single phase, 60 Hz
electrical, lighting, appliance, tool and motor loads.
12
L - 120 Volt AC, 30 Amp Locking Receptacle — May be
used to supply electrical power for the operation of
120 Volt AC, 30 Amp, single phase, 60 Hz electrical
lighting, appliance, tool and motor loads.
M - 120 Volt AC, 20 Amp, Duplex Receptacle — May be
used to supply electrical power for the operation of
120 Volt AC, 20 Amp, single phase, 60 Hz electrical,
lighting, appliance, tool and motor loads.
N - 12 Volt DC Receptacle — Use this receptacle with
battery charge cables to charge a 12 Volt battery. This
receptacle is protected by a 10 Amp auto reset circuit
breaker.
P - Rocker Switch Circuit Breaker — The 120/240 Volt AC,
30A locking receptacle and the 120 Volt AC, 30A locking
receptacle is provided with a 2 pole rocker switch circuit
breaker to protect the generator against electrical
overload.
R - Idle Control Switch — Use this switch to turn the idle
control feature on and off.
S - Run/Stop Switch — Set this switch to "Run" before
starting. Set switch to "Stop" to switch off engine.
T - Circuit Breakers (AC) — The 120 Volt AC, 20A duplex
receptacle is provided with "push to reset" circuit
breakers to protect the generator against electrical
overload.
T
S
R
P
N
M
L
K
J
H
G
F
BRIGGSandSTRATTON.COM