Rubber Bellows For Propeller Shaft; Electrical; Head Lamp Bulb Removal; Tail/Brake/ Rear Turn Signal Lamp Bulb - TVS King GS+ Owner's Manual

Rubber bellows for propeller shaft

Rubber bellows
Bellows should be kept in good condition and replaced
immediately if torn or cracked by approaching our Dealer or
Authorized service centers.
Torn or cracked bellows allow dust and water into the
propeller shaft flanges which will cause damage to flange,
slider block and pins. Inspect the bellows regularly.

ELECTRICAL

Head lamp bulb removal

To replace bulb
- Remove the rubber boot ( A ) from reflector housing
which is located under the dash board
- Un-lock the clip (B) to take out the bulb holder assembly.
SELF MAINTENANCE PROCEDURE
B
A
Head lamp bulb removal
- Push the bulb in and turn it in anti-clockwise direction to
remove the bulb from holder ( C ).
- Push the new bulb in and turn it in clockwise direction to
fit new bulb.
- Insert holder into reflector housing and lock the holder
clip. Reinsert rubber boot.

Tail/brake/ rear turn signal lamp bulb

- Loosen and remove screws holding the lens.
- Remove lens. Push in and twist in anti clockwise direction to
remove bulb.
- Replace bulb and assemble back in reverse order of
disassembly.
C
33