4.8
THE MODULATION MATRIX
The minimoog V increases the original possibilities of modulation thanks to the presence
of the modulation matrix in the extension. This extension appears when the minimoog V
is in open position.
This matrix can be activated or deactivated with the selector in the task bar above the
synthesizer.
The matrix allows 6 modulation connections. To activate a connection, select a source of
modulation by clicking in the «source» zone, next select a parameter to modulate in the
«destination» zone, an set the rate of modulation with the «Amount» knob.
The sources of modulation are as follows:
•
VCO3:
•
EG Filter:
•
EG VCA :
•
Pitch Bend:
•
ModulationWheel:
•
AfterTouch:
•
FootExp:
•
Velocity:
•
LFO:
•
Keyboard follow:
•
External In:
•
VCA out:
•
Off:
The parameters that can be modulated are as follows:
•
VCO1 FM:
•
VCO1 PWM:
•
VCO1 AM:
•
VCO2 FM:
•
VCO2 PWM:
•
VCO2 AM:
•
VCO3 FM:
•
VCO3 PWM:
•
VCO3 AM:
•
Noise AM:
•
Ext. AM:
34
ARTURIA – minimoog V – USER'S MANUAL
Modulation matrix
Activation of the modulation matrix
Output of oscillator 3
Filter envelope output
VCA envelope output
Pitch Bend wheel
Modulation wheel
Polyphonic after touch/Channel pressure
Expression pedal
Velocity
LFO output
Key follow output
External input signal
VCA output signal
Disconnecting the source of modulation
Frequency of oscillator 1
Impulse width of oscillator 1
Output level of oscillator 1
Frequency of oscillator 2
Impulse width of oscillator 2
Output level of oscillator 2
Frequency of oscillator 3
Impulse width of oscillator 3
Output level of oscillator 3
Output level of noise generator
Level of the audio external input