Bushnell PRIME L20 Instruction Manual page 17

Camera stops taking images or won't take images
1. Please make sure that the SD card is not full. If the card is full, the
camera will stop taking images.
2. Check the batteries to make sure that they are new alkaline or lithium
AA batteries. See note above about short battery life.
3. Make sure that the camera power switch is in the "On" position and
not in the "Off" or "AIM" modes.
4. Make sure that you are using a good quality SD card in your camera.
Bushnell recommends SanDisk® SD Cards up to 32GB.
5. If the SD card has its write protect switch in the lock position, the
camera will not take images.
6. If you have used an SD card in another device before inserting it in
your Prime L20 Trail Camera, you might want to try formatting the card
using the "Format" parame- ter in Setup mode (make sure you have
backed up any important files first, as formatting will erase all previous
files). In some cases, other devices may change the formatting of
the SD card so that it will not work properly with the Prime L20 Trail
Camera.
Camera won't power up
1. Make sure that you have installed all six batteries in the battery
compartment.
Bushnell recommends using Energizer® Lithium AA batteries in all
Prime L20 Trail Cameras.
2. Make sure that the batteries are installed correctly, observing proper
polarity. Always place the negative (flat) end of each battery in contact
with the spring side of its slot inside the camera.
3. After moving the switch from "Off" to "AIM" or "On", make sure that
the switch is correctly in position to ensure the proper mode (avoid
positions "between" two modes).
4. Do not move the switch directly from "On" to "AIM"-always move the
switch all the way down to "Off" first, then back up to "AIM".
Still Photo and/or Video Quality Problems
1. Night photos or videos appear too dark
a. Check the battery indicator icon to see if battery power is full. The
flash will stop operating near the end of the battery life.
b. You will get the best results when the subject is within the ideal flash
range, no farther than 100' (30m) from the camera. Subjects may
appear too dark at greater distances.
17