Bushnell PRIME L20 Instruction Manual page 10

Setting Time and Date
After the Initial Setup screen, the next few display screens will allow
you to set the current time and date, so the time/date stamp imprinted
on all your photos and videos will be accurate when captured by the
camera. To change the Time and Date to be current, starting at the
default "12 : 00" screen:
1. Press OK and use UP/DOWN to set the hour (24 hr/military time
format). Press OK to confirm.
2. Use UP/DOWN to set the minute. Press OK to confirm.
3. Use UP/DOWN to set the month. Press OK to confirm.
4. Use UP/DOWN to set the date. Press OK to confirm.
5. Use UP/DOWN to set the year. Press OK to confirm and move on to
the next Setup item, Interval Time.
Setting Interval (Detection Delay) Time
The Interval or Detection Delay option lets you set the time between
captured images when an animal remains within the camera's sensor
range after it is first detected and the camera is triggered. Use UP/
DOWN to select 5 sec (display shows "00:05"), 15 sec (default value),
30 sec, 1 min (display shows "01:00") or 5 min. Press OK after setting.
10