8 - SPECIFIC PRODUCT INFORMATION 8.1 Technical characteristics 8.2 Nomenclature of parts 8.3 Installation 8.4 Mode of use 9 - CHECKS BEFORE AND AFTER USE 10 - CERTIFICATION PICTOGRAM’S LEGEND MARKING LEGEND SERIAL NUMBER LEGEND CONTROL CARD www.kong.it CEVEDALE MONO...
- suitable for use: only the techniques that personnel. are not crossed out are permitted, any other use is considered improper and G) It is strictly forbidden to modify and/or therefore potentially dangerous. repair the device. www.kong.it CEVEDALE MONO...
H) Avoid exposing the device to heat sources L) All our devices are tested/inspected piece or to contact with chemical substances. by piece in accordance with the procedures Reduce direct exposure to the sunlight to a of the Quality System certified according minimum, particularly for textile and plastic to the UNI EN ISO 9001 standard.
Except in the case of more stringent legal periodic inspections must be recorded on requirements, devices must be inspected the device’s inspection chart. www.kong.it CEVEDALE MONO...
5 DEVICE LIFE Read point 1C very carefully. The life of use, post-use and periodic inspections are metal devices is theoretically unlimited, all positive, and the device is used correctly, while textile and plastic devices can last 10 not exceeding 1/4 of the indicated load. years from the date of production as long Discard any devices that do not pass the as: maintenance and storage are carried out...
8 SPECIFIC INFORMATION Note: for rescue maneuvers with descents This class III Personal Protection Device, 842.010 known as a CEVEDALE MONO longer than 2 meters, connect to the (fig. 1) is a: anchorage points a descender device - Type B anchoring device that conforms conform to EN 341 (eg: 801.000 “Indy Evo”...
8.1 Technical characteristics - Device dimensions: shown in figure 2 - Maximum load transmitted to the ground: 15 kN (5 kN for each leg) - Maximum lifting / lowering load, using a manual winch (I): 1,5 kN - Maximum load that can be applied to a single anchoring point (B/H): 12 kN - Maximum load that can be applied simultaneously to the anchoring points (B1/H): 15 kN - Device weight: 20 kg 8.2 Nomenclature of parts...
(well, manhole) - fig. 5. WARNING The support surface for the tripod must be flat, stable and be able to withstand the maximum load transmitted ground, indicated in point 8.1. www.kong.it CEVEDALE MONO...
8.4 Mode of use 8.4.1 - Anchoring points WARNING The following can be connected to the - Do not use more than 3 anchoring anchoring points (B and H): points simultaneously. - Flexible anchoring lines - The lines connected anchoring points located on the leg - Safety lines - Working lines (H) must be connected to one of...
Page 11
3 turns (fig. 7A), position (fig. 8). - Pass it over the self-tailing tooth (I1) as shown in figure 7B, - Secure it in the groove in the self-tailing unit (I1) at least 1 turn, as shown in figure www.kong.it CEVEDALE MONO...
Page 13
- Allow the rope to slide slowly over the drum, for the lowering distance (fig. 9C). - On completion of the lowering procedure, repeat the lifting procedure and move the back-up device’s selection lever back to the “lock mode” position (fig. 7B, 7C, and 9D). www.kong.it CEVEDALE MONO...
Page 14
Examples of correct use: - Fig. 10 - Access to a confined space - Fig. 12 - Access to a confined space using equipped with a ladder, and related a working line, and related evacuation of evacuation of the operator (fig. 11). the operator (fig.
- The winch drum rotates without any friction, when the crank handle is rotated clockwise and anti-clockwise. 10 CERTIFICATION This equipment is certified by accredited body no. 0123 - TÜV SÜD Product Service GmbH Ridlerstraße 65, D-80339 Munich - Germany. www.kong.it CEVEDALE MONO...
PICTOGRAM’S LEGEND n° Figures number Improper use, may be very dangerous! Never do it: risks of fatal accident! Correct use Absolutely no correct use MARKING LEGEND Conform Directive 89/686/EEC ITALCERT 0426 Notified body for production inspection V.le Sarca, 336 20126 Milano - Italia Conform EN 795/B:12 EN 795:2012 Type B...
3 - Batch number 4 - Date of purchase 5 - Place of purchase 6 - Date of first use 7 - Name the user 8 - Date inspection 9 - Result 10 - Comments 11 - Signature www.kong.it CEVEDALE MONO...
Page 18
KONG s.p.a. Via XXV Aprile, 4 - (zona industriale) I - 23804 MONTE MARENZO (LC) - ITALY Tel +39 0341630506 - Fax +39 0341641550 - info@kong.it www.kong.it...
Need help?
Do you have a question about the CEVEDALE MONO and is the answer not in the manual?
Questions and answers