SPX Marley Geareducer 32.2 Series User Manual

SPX Marley Geareducer 32.2 Series User Manual

Advertisement

Quick Links

u s e r m a n u a l
®
Geareducer
model 32.2
I N STA L L AT I O N - O P E R AT I O N - M A I N T E N A N C E
Z0238997_B
ISSUED 09/2016
READ AND UNDERSTAND THIS MANUAL PRIOR TO OPERATING OR SERVICING THIS PRODUCT.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Marley Geareducer 32.2 Series and is the answer not in the manual?

Questions and answers

Summary of Contents for SPX Marley Geareducer 32.2 Series

  • Page 1 u s e r m a n u a l ® Geareducer model 32.2 I N STA L L AT I O N - O P E R AT I O N - M A I N T E N A N C E Z0238997_B ISSUED 09/2016 READ AND UNDERSTAND THIS MANUAL PRIOR TO OPERATING OR SERVICING THIS PRODUCT.
  • Page 2 operation and service Corrosion and Dry Start-Up Protection As shipped, a Marley Geareducer is protected internally against corrosion with machine enamel on un-machined parts and with Marley Geareducers utilize iron and steel materials, which if not rust-proofing oil and grease on machined surfaces. These coatings maintained correctly, may degrade.
  • Page 3 operation and service Long-Term Storage or Downtime The Geareducer vent or vent line must be checked for blockage indefinite duration to prevent failure of pinion shaft oil seal—clean when necessary. If unit has been in an operational state, perform a Run Cycle and drain the oil including volume in the oil line, if equipped.
  • Page 4 operation and service Detail A Spiral Bevel Gear Tooth Pattern Detail B Helical Gear Tooth Pattern...
  • Page 5 operation and service Service and Lubrication Alternate procedure: If the cooling tower has an external oil gauge and drain line The horizontal part of the oil gauge and drain line must be level or equipped with three-way valve below sight glass the following slightly lower at the sight glass than it is at the Geareducer.
  • Page 6 operation and service Oil Filter Service To replace the filter cartridge, first drain the oil from the Geareducer case, then remove the drain plug from the oil filter case. See Figure 3. 1. Remove the four cap screws attaching the oil filter case cap, and remove cap.
  • Page 7 operation and service If lubricants other than Marley factory lubricants are used, they must not contain any additives (such as detergents or EP addi- tives) which are adversely affected by moisture and could reduce the service life of the Geareducer. The responsibility for use of lubricants other than Marley factory lubricants rests with the customer/owner and the lubricant supplier.
  • Page 8 7401 WEST 129 STREET Z0238997_B (M92-1436B) ISSUED 09/2016 OVERLAND PARK, KS 66213 USA COPYRIGHT © 2016 SPX CORPORATION In the interest of technological progress, all products are subject to design 913 664 7400 | spxcooling@spx.com and/or material change without notice.

Table of Contents