Panasonic SG-P Series Instruction Manual page 9

● Machine designer, installer, employer and operator
• The machine designer, installer, employer and operator are solely responsible to ensure that all
applicable legal requirements relating to the installation and the use in any application are
satisfied and all instructions for installation and maintenance contained in the instruction
manual are followed.
• Whether this device functions as intended to and systems including this device comply with
safety regulations depends on the appropriateness of the application, installation, maintenance
and operation. The machine designer, installer, employer and operator are solely responsible
for these items.
● Engineer
• The engineer would be a person who is appropriately educated, has widespread knowledge
and experience, and can solve various problems which may arise during work, such as a
machine designer, installer or employer etc.
● Operator
• The operator should read this instruction manual thoroughly, understand its contents, and
perform operations following the procedures described in this manual for the correct operation
of this device.
• In case this device does not perform properly, the operator should report this to the person in
charge and stop the machine operation immediately. The machine must not be operated until
correct performance of this device has been confirmed.
● Environment
• This device is suitable for indoor use only.
• Do not use this product in an explosion-proof area.
• Do not install this device in the following places:
1. Areas with high humidity where condensation is likely to occur
2. Areas exposed to corrosive or explosive gases
3. Areas exposed to contact with water
4. Areas exposed to too much steam or dust
• Do not use this device near equipment that emits strong electromagnetic waves.
● Machine in which this device is installed
• Do not install this device with a machine whose operation cannot be stopped immediately in
the middle of an operation cycle by an emergency stop equipment.
• This device starts the performance after approximately 2 seconds from the power ON. Have
the control system started to function with this timing.
• Do not use the device improperly or do not invalidate the settings after installing the device.
Otherwise, the safety functions of the apparatus which uses this device may not work properly,
resulting in death or serious injury.
• Do not install the switch body of this device on a movable door.
• When installing this device, always consider the time required to ensure a safe state and
provide a distance equal to or longer than the correctly calculated safety distance between the
apparatus which uses this device and the dangerous parts of the machine.
• Confirm that the response time of the entire machine is less than the calculated value before
designing the equipment.
● Wiring
• Be sure to carry out the wiring in the power supply OFF condition.
• All electrical wiring should conform to the regional electrical regulations and laws. The wiring
should be done by engineer(s) having the special electrical knowledge.
WUME-SGPUM-2
1.1 Safety Precautions (Always observe)
1-3