Installation And Connection - Foster 2037 000 Detailed Instructions For Use

INSTALLATION AND
CONNECTION
SELECTING THE ROOM
• Install the appliance in a dry and well ventilated room. The appliance will
operate correctly if the environment temperature is in the interval specifi ed in
the table. The appliance class is indicated on the rating plate / label with the
basic information on the appliance.
Class
SN (subnormal)
N (normal)
ST (subtropical)
T (tropical)
i
• Do not place an appliance in a room where temperature can drop to
below 5 °C as this may cause abnormal appliance operation or failure!
• After the installation, the appliance mains plug should be accessible!
• Do not place the appliance near appliances or devices radiating heat, such as
a cooker, a stove, a radiator, water heater etc., and do not expose it to direct
sunlight. The appliance should stand at least 3 cm away from an electric or gas
cooker or at least 30 cm away from an oil or solid fuel stove. If the distance
between such source of heat and the appliance is smaller, use an insulating
panel.
Note: Place the appliance in a suffi ciently large room. There should be at least
1 m 3 of space per 8 grams of refrigerant. Amount of refrigerant is indicated on
the rating plate in the appliance interior.
• There should be an opening or a vent of at least 200 cm
appliance, and the clearance between the appliance and any cabinet above it
should be at least 5 cm, to allow cooling of the condenser unit.
Warning: When installing appliances next to each other (side by side) that
are taller than 1700 mm, an anti-condensation kit needs to be purchased and
installed, should the humidity in the room where the appliances are installed
exceed 70%. For safety reasons, dew prevention kit may only be installed by
an authorized service technician!
Order code: 376078 (appliances higher than 1,700 mm)
10
Temperature
from +10 °C to +32 °C
from +16 °C to +32 °C
from +16 °C to +38 °C
from +16 °C to +43 °C
Relative Humidity
75%
2 behind the