Enabling Bbmd Functionality On The Ip Network - Trane Tracer UC600 Installation, Operation And Maintenance Manual

Enabling BBMD Functionality on the IP Network

The following instructions provide example configuration settings when both the Tracer-App and
the Tracer SC-Base both reside on separate subnets and a BBMD is required for both.
To configure the Tracer SC-App:
1. Log on to the Tracer SC-App controller.
2. Navigate to the Identification and Communications section on the Tracer SC Installation page.
3. Click the IP Configuration tab and then click Edit.
4. Click the Use the Following Address radio button and enter the following:
5. Click Save. An error message appears stating that Tracer SC will restart. Click OK.
6. Return to the Identification and Communications page. Click the BACnet Configuration tab,
7. Select the check box in the This Tracer SC is a BACnet Broadcast Management Device (BBMD)
8. Click Save.
To configure the Tracer SC-Base:
1. Log on to the Tracer SC-Base controller.
2. Navigate to the Identification and Communications section on the Tracer SC Installation page.
3. Click the IP Configuration tab and then click Edit.
4. Click the Use the Following Address radio button and enter the following:
5. Click Save. An error message appears stating that the Tracer SC will restart. Click OK.
6. Return to the Identification and Communications page. Click the BACnet Configuration tab and
7. Select the check box in the This Tracer SC is a BACnet Broadcast Management Device (BBMD)
8. Click Save.
To set up a BDT table, see
BAS-SVX45F-GB
IP address — 192.168.1.10
Subnet Mask — 255.255.255.0
Default Gateway — 192.168.1.254
then click Edit.
field.
IP address — 192.168.1.20
Subnet Mask — 255.255.255.0
then click Edit.
field.
"Setting Up a BDT, " p.
Appendix A: Configuring Tracer UC600 for BACnet/IP
81.
77