Clone Ez; Cloning Yourh - Apricorn EZ-BUS-DTS-EKIT User Manual

C. Cloning your hard drive with Clone EZ
1. Read all instructions carefully before cloning. To clone your hard
disk drive, your computer will need to boot directly to the EZ Gig II
CD provided in the kit.
to use Clone EZ. For detailed instructions and explanations, read the
Clone EZ manual located on the EZ Gig II CD. If you are going to use
your FireWire connection for cloning, you do not need to boot directly
from the CD and can access through Windows (Start Programs Apricorn
Apricorn EZ Gig II - click on Clone EZ and follow the directions).
2. Turn on your computer and change the BIOS setting so that the computer
boots to the CD-ROM. Consult your computer manufacturer or
computer manual on how to make changes to the BIOS (basic
input/output system). Apricorn will not have this information.
Once you have accessed the BIOS and recorded the settings, change the
boot sequence so that CD-ROM is the fi rst selection. Save the changes
and continue with cloning your hard drive.
3. Open the CD-ROM drive. Place the EZ Gig II CD into the CD-ROM drive.
Close the CD-ROM drive. Turn off your computer.
4. Ensure EZ Bus DT is connected to your computer using the USB cable
provided (EZ Gig II may not work properly with a FireWire Connection).
Also, be sure that the AC Adapter is attached to the EZ Bus DTC to
supply power to the unit.
5. Turn on your computer. When EZ Gig II has successfully booted, you
will see the "Welcome to Apricorn Clone EZ" screen. Click Next to
continue.
These steps are just a quick overview of how
www.apricorn.com 10