Apricorn EZ-BUS-DTS-EKIT User Manual page 8

3. HARD DRIVE INSTALLATION FOR EZ BUS DT KIT
Only the EZ Bus DT Kit is shipped without a hard disk drive. If you have
purchased an EZ Bus DT with a hard drive, proceed to section 4 (page 6).
To install your 3.5" hard disk drive, follow the instructions below:
Step 1. Pull and rotate the rubber plugs located on the side of the
enclosure.
Step 2. Gently remove the top cover from the enclosure. You should see
two cables without anything attached to them. These will connect
to your hard disk drive.
Step 3. Set your hard disk drive to Master (please consult your hard drive
manufacturer/manual), then attach the fl at cable and the power
cable to the hard disk drive. Gently place the hard disk drive into
the enclosure. Check to make sure the hard disk drive lines up
with the screw holes on the enclosure.
5 The Leader in Personal Storage