Advertisement
Available languages
Available languages
Manual: Club Series CS-250G /CS-400G /CS-800G /CS-1200B
•
operation, the device should cool down
for about 15 minutes.
•
As for troubleshooting, please check the
FAQ on our website www.laserworld.com
6. Warnings and other notices on the device
Please read manual before operation
Laser radiation!
Avoid exposure
to beam.
Laser class 4
Caution of
radiation if cover
is removed
Use in enclosed spaces only!
7. Device connections
micro*
LED signal*
*CS 800G: on the rear side of the device
page 6 / 20
• Removal of the warranty label as well
as damages to the device caused by
improper handling, neglect of the sa-
fety instructions and service notes will
void the warranty.
Output power
wavelength
model type
production
year
power supply
& consumption
DMX address
fan
trim pot for
sensitivity control
connection for power
DMX out DMX in
supply
8. Operation
1.
Connect the power cable to the device and then to the mains
2.
Press „ON" to switch the device on
3.
Your device runs in auto mode:
Your device runs in music mode:
4.
5.
Control the music-sensitivity by the trim pot at the rear side of the device. The LED is
flashing when the device is triggered.
Your device runs in DMX mode if '10' is switched off:
6.
7.
Connect a DMX controller to operate the laser.
8.
Use the switches 1 - 9 to set the DMX address of the laser. Each switch represents a num-
ber. To define a number use the preceding number and multipy it by 2:
Switch
1
ILDA in
ILDA out
Number 1
key switch
Interlock
The laser uses 11 DMX channels, so make sure that the next device uses an address that doesn't
overlap with this range.
on / off switch
Manual: Club Series CS-250G /CS-400G /CS-800G /CS-1200B
2
3
4
5
6
7
2
4
8
16
32
64
8
9
10
128
256
Mode Switch
page 7 / 20
Advertisement
