Inspection Checklist - Task Force Tips ULTIMATIC Instructions For Installation, Safe Operation And Maintenance

10.0 INSPECTION CHECKLIST

Nozzle must be inspected for proper operation and function according to this checklist before each use.
Check that:
1) There is no obvious damage such as missing, broken or loose parts, damaged labels etc.
2) Gasket grabber is free of debris.
3) Coupling is tight and leak free.
4) Valve operates freely through full range and regulates fl ow.
5) "OFF" position does fully shut off and fl ow is stopped.
6) Nozzle fl ow is adequate as indicated by pump pressure and nozzle reaction.
7) Shaper turns freely and adjusts pattern through full range.
8) Shaper turns into full fl ush and out of fl ush with normal fl ow and pressure restored.
Any Ultimatic, Mid-Matic or Handline nozzle failing any part of the inspection checklist is unsafe
WARNING
and must have the problem corrected before use. Operating a nozzle that fails any of the above
inspections is a misuse of this equipment.
TASK FORCE TIPS, INC.
MADE IN USA • www.tft.com
©Copyright Task Force Tips, Inc. 2002 - 2012
3701 Innovation Way, Valparaiso, IN 46383-9327 USA
800-348-2686 • 219- 462-6161 • Fax 219-464-7155
LIN-030 February 14, 2012 Rev13