S/Pdif And Word Clock Output; Battery Operation; Other 12 Volt Sources - Apogee AD-1000 Operating Manual

AD-1000 Operating Manual
S/PDIF and Word Clock (WC) Output Operation
The S/PDIF and Word Clock (WC) outputs are available on the 15-pin HD connector on the rear of the AD-1000
(the same connector that is the power supply input). This cable can be ordered from your Apogee dealer (PS-
1000/AD-1000 cable) or use the diagram overleaf if you want to make it yourself. Please note the WC output is
on different pins than on the AD-500, so the equivalent AD-500 cable (PS-1000/AD) will not work on the AD-
1000.

Battery Operation

A 12 volt 7.2 Amp/hours lead-acid battery (NiCad batteries are not recommended) can be used for portable or
field operation. You will need to interface the battery leads with the 15 pin HD connector – see drawing for
pinouts. For battery information contact Eco Charge in Boulder, CO 1-800-361-5666. The AD-1000 can also be
powered from a car battery.

Other 12 Volt sources

Any good regulated 12 V DC, 1.5 amp linear power supply will sufficiently power the AD-1000. We do not rec-
ommend using a switch-mode type power supply. In addition, we do not recommend the use of the TT-1200
"table-top" PSU designed for the AD-500. The AD-1000 takes more current than the TT-1200 can provide.
Page 43