Related Manuals for Apogee AD-16
Summary of Contents for Apogee AD-16
- Page 1 A A D D - - 1 1 6 6 24-bit 16-channel A/D Converter Owner’s Manual v1.1 – April 2002...
- Page 2 This manual is copyright ©2002 by APOGEE ELECTRONICS CORPORATION. All rights reserved. Under copy- right laws, this manual may not be duplicated in whole or in part without the written consent of Apogee. Just drop us an email and tell us why you need to copy it.
- Page 3 Apogee AD-16 User’s Guide A A D D - - 1 1 6 6 24-bit 16-channel A/D Converter Owner’s Manual v1.1 – April 2002...
-
Page 4: Warnings
AC voltage ratings for electrical power vary from area to area. Severe damage to your unit is possible if your DA-16 is configured incorrectly for your local power. If in doubt, consult an Apogee dealer. A label adjacent to the power connector indicates the voltage to which the unit was set on leaving the factory. -
Page 5: Registration & Warranty Information
This warranty is void if Apogee determines, in its sole business judgment, the defect to be the result of abuse, neglect, alteration or attempted repair by unauthorized personnel. -
Page 6: Declarations Of Conformity
• 89/336/EEC – EMC Directive Declaration of Conformity – Japan Apogee Electronics Corporation hereby declares that the AD-16, to which this declaration relates, is in mater- ial conformity with the VCCI Class A standard. Declaration of Conformity – Australia Apogee Electronics Corporation hereby declares that the AD-16 is in material conformity with AN/NZS stan- dard requirements. -
Page 7: Owner's Record
The serial number is located on the rear panel of the unit. We suggest you record the serial number in the space provided below. Refer to it whenever you call an authorized Apogee Electronics repair facility or the manufac- turer. Please be sure to return your completed warranty card immediately! AD-16 Serial No. -
Page 8: About This Manual
Apogee. Remember — before calling technical support at Apogee, you should register this product either by send- ing in the registration card or by registering on the Apogee Web site (http://www.apogeedigital.com). The tech- nical support specialist will refer to the manual during your call and will expect that you have read it and under- stand the product to some degree. -
Page 9: Table Of Contents
Analog Input Pinout Level Trim ................................14 Application Notes ......................14 Tracking Mixing Mastering Calibration........................15 Procedure Restoring Default Values Internal Adjustments ......................15 Voltage Selector Fuses AD-16 Specifications .......................16 See the Apogee web site – www.apogeedigital.com – for additional technical notes and documentation. Page 9... - Page 10 Apogee AD-16 User’s Guide This page intentionally left blank. Page 10...
-
Page 11: Introduction
UV22HR word length reduction technology. The converters sync to internal clocks or to an external Word Clock through the use of Apogee low jitter clock technology. Digital outputs are ADAT lightpipe as standard and can be configured to output Sonorus S/MUX protocol for sample-splitting high-resolution signals into optical interfaces. -
Page 12: Channel 1-16 Over Leds
Apogee AD-16 User’s Guide Channel 1-16 OVER LEDs These LEDs will illuminate when a digital OVER is sensed at the digital output for the respective channel. These can be set to automatically clear after 2 seconds or infinite hold with rear panel DIP switch #2. The number of consecutive samples containing “all ones”... -
Page 13: Aes Digital Pinout
Apogee AD-16 User’s Guide AES Digital Pinout The AES output is delivered through a single, female DB25 connector. The AES I/O MALE DB25 pinout is similar to the “Yamaha” DB25 specification, except that all channel pairs are configured as outputs. The pinout is as follows:... -
Page 14: Level Trim
Apogee AD-16 User’s Guide Level Trim These multiturn trimmers adjust the level sensitivity of the individual A/D sections. As discussed in the METERS description, digital and analog scales are different. The level trim posts allow you to set the AD-16 to an oper- ating level that is convenient for your particular application. -
Page 15: Calibration
Apogee AD-16 User’s Guide This page intentionally left blank. Page 15... -
Page 16: Ad-16 Specifications
Apogee AD-16 User’s Guide AD-16 Specifications Inputs: 16 analog inputs, balanced Word Clock Outputs: Four TosLink interfaces delivering 2 x 8 channels in ADAT mode and 4 x 4 for S/MUX. Optional AES/EBU & TDIF cards Word Clock Resolution: 24-bit Sample Rates: 44.1, 48, 88.2, 96 kHz ±10%... - Page 17 Please register your Apogee products! You need to be registered to qualify for Technical Support. Please be sure to register all the Apogee products you own. You can register either with the registration card provided in this package, or on-line at: http://www.apogeedigital.com/register.html...