Table of Contents
Advertisement
AntMiner Manual
Last updated: 3/26/2015
Page 8 of 11
software will take approximately 10 seconds to connect to the server, and then the client
software continues to run after settings are saved. If either the Off/On is selected to 'OFF' or the
UID is left blank, Miner Link will remain disabled.
4.3.4 Once 'Miner Link' is enabled, the 'Server Addr' will become fixed and cannot be updated by
customers. This refers to Bitmain's monitoring server address.
6 Miner Status
You can check the operating status of your miner on 'Miner Status' page.
ASIC#: Number of chips detected in the chain
Frequency: ASIC frequency setting
Temp: Temperature, centigrade
ASIC status: o stands for OK, x stands for error.
Page 8 / 11
Advertisement
Table of Contents
Need help?
Do you have a question about the AntMiner S5 and is the answer not in the manual?
Questions and answers