Table of Contents
Advertisement
AntMiner Manual
Last updated: 3/26/2015
Page 7 of 11
5 Miner Configuration
5.1 Pool Setting
You can configure your miner through 'Miner Configuration->General Settings'.
Pool URL- Enter the URL of your desired pool in this column.
Worker- This is your worker ID on the selected pool.
Password- This is the password for your selected worker.
Comment:
4.1.1 The AntMiner S5 can be set up with three mining pools, with decreasing priority from the
first pool (pool 1) to the third pool (pool 3). The pools with low priority will only be used if all
higher priority pools have gone offline.
4.1.2 When 'Beeper ringing' is checked, a beeper will ring when the miner stops mining,
otherwise it won't ring even if the miner stops mining.
4.1.3 When 'Stop running when temperature is over 80℃' is checked, the miner will stop mining
when the temperature exceeds 80℃ to protect the miner. If it's unchecked, the miner will still
mine even in high temperature.
Click 'Save & Apply' to save and restart miner.
5.2 Frequency Modification
You are able to modify the frequency value through 'Miner Configuration->Advanced Settings'.
The default frequency for the AntMiner S5 is 350M.
5.3 Miner Link Connection
4.3.1 Go to 'Miner Configuration' tab, and the 'Miner Link' tab in order to configure the relevant
settings.
4.3.2 You can enable or disable Miner Link in the Off/On drop-down list provided. You can fill in
your Bitmain username(your passport email registered on Bitmain platform) in the UID blank.
(Register here if you don' have an account yet: http://passport.bitmain.com)
4.3.3 After filling in your Bitmain username and enabling Miner Link, click 'Save&Apply' tab. The
Page 7 / 11
Advertisement
Table of Contents
