Table of Contents
Advertisement
5 Miner Status
5.1 Miner Status web page
Through 'Status->Miner Status', you will be able to check your AntMiner running status.
ASIC#: The number of ASIC in the chain
Fan: Fan speed
Temp: Temperature, centigrade
Frequency: ASIC setting frequency
ASIC status: o stands for OK, x stands for error.
5.2 LED status during boot procedure
1. When power on, Red LED flashes on and off, Green LED is off, the LEDs (Yellow LED and
Green LED) for Ethernet interface are off.
2. When upgrading, the Red LED flashes on and off quick, and changes to be on after finishing
upgrade. If AntMiner doesn't upgrade the firmware, Red LED flashes on one time then into
STANDBY Mode.
3. LEDs (Yellow LED and Green LED) for Ethernet interface, Yellow LED is on, Green LED flashes
on and off.
4. Start to mine, Red LED is off, Green LED flashes quick.
5. Stop mining, AntMiner switches to STANDBY Mode.
5.3 Fault Indication: Beeper and LED status
1. Beeper rings by default when AntMiner faults. You are able to configure if beeper ring alarm
through 'Status-> Miner Configuration'. You are also able to configure if AntMiner is
continuing mining when the ambient temperature is higher than 80 degrees centigrade on
AntMiner S3 Manual
Last updated: 7/18/2014
Page 6 of 8
Page 6 / 8
Advertisement
Table of Contents
