RADAC WaveGuide 5 Direction User Manual page 45

Indicator pattern
Off
Solid on
Blink 1 time
Blink 2 times
Blink 3 times
Blink 3 times
Definition
No power connected.
Power is connected and the system is
starting.
The system is up and running, but no
network is detected.
The system is working normally.
The ip address was set to the default
192.168.111.71.
The system was reverted to the factory
defaults. Also the default ip address
192.168.111.71 was set.
Table 11: Blinking modes
37
Remark
Wait for 2 minutes, after which the in-
dicator should change its behavior.
Check the network cable connections.
This is the default mode.
Check chapter 3 on how to connect to
the sensor.
On release of the reset contact the sys-
tem will be restarted.