Step 3. Configuration; Step 3.1: Set System Date And Time - RADAC WaveGuide 5 Direction User Manual

Step 3. Configuration
The configuration page contains five sections as listed in Table 3.1.
Link
Date&Time
Network
Sensor
Subscriptions To set up data export over the serial ports or over the network.
Data Logger

Step 3.1: Set system date and time

In order to ensure an accurate timestamping of the data, the WaveGuide system runs an
NTP time service to automatically correct its system time to UTC time. For the NTP
service to work, the system needs to be connected to the Internet, as it needs to be able to
reach its default NTP servers.
In the case that the NTP servers can not be reached, it is possible to manually set the
system date and time using the "Date&Time" menu (Fig. 3.3). Adjusting the date and
time while the NTP service is running is not possible as the time will be automatically
corrected back to UTC time. The date and time are kept by an on-board clock. Please be
aware that such on-board clocks are not highly accurate and can drift over the years while
the system is used; it is thus advised to use the NTP service.
Description
For viewing and setting the system time.
For viewing and changing the network settings.
For viewing and changing the sensor specific settings and for view-
ing reflection diagrams.
To log data on a USB drive.
Table 3.1: Description of configuration page sections.
Figure 3.3: Setting the system time and date.
18