Siphon Cup; Setup; Cleaning - Graco 249258 Instructions - Parts Manual

Siphon Cup

Setup

1. Push clamp lever (A) fully to the unclamped posi-
tion, against the yoke (B). See F
2. Twist cup lid (101) counterclockwise to disengage
the yoke hook from the extended cup pins (C).
3. Remove the cup lid (101) and fill cup (103) with
fluid.
4. Verify gasket (102) is installed on the bottom of the
cup lid (101). Twist the cup lid (101) clockwise to
engage the yoke hook (B), then push the clamp
lever (A) fully to the clamped position. Use your
thumb to force the clamp lever into position; do not
use wrenches or tools to move it.
5. Securely connect the cup assembly onto the gun
fluid inlet, using a wrench on the swivel nut (D).

Cleaning

1. Push the clamp lever (A) fully to the unclamped
position, against the yoke (B). See F
2. Twist the cup lid (101) counterclockwise to disen-
gage the yoke hook from the cup extended pins (C).
3. Remove the cup lid (101).
4. Clean the cup lid (101) and cup (103) with solvent.
CAUTION
When cleaning the cup lid (101), avoid prolonged
exposure of the gasket (102) to solvent as this will
cause it to swell.
5. Spray clean solvent through the gun until all fluid
passages are clean.
311241A
. 3.
IG
. 3.
IG
F
A
101
102
103
. 3
IG
Siphon Cup
D
B
C
5