KIKKA BOO AMAIA Instructions For Use Manual page 8

This car seat has been tested and approved according to the newest version of the ECE-R44/04 regulation. It's approved with the
"universal" category. This car seat child restraint system is suitable for weight classes0+, i.e. for children weighing between 0 to 13kg
(approximately new born to 15 months).The 3 point harness system must be used. Please observe the proper use of the harness system
(Figure IX).For use in your vehicle, please also follow the car manufacturer's manual, or contact your car dealer.
II.To gain the most comprehensive protection for your child, the car seat must be used exactly as described in this manual. You can store
these instructions in the instruction slot (Figure II) provided on the rear of the backrest of your seat.
III. REMOVE THE SEAT CUSHION
This car seat must be used for children from 0 to 10kg (approximately new born to 10 months old with the seat cushion. Once your child
's weight is between 10 kg to13kg (the approximately 10 months to approximately 15months) you must remove it as below: Press on
the release button and separate the buckle tongue.Then pull at the edge of the seat cursion to remove it.
IV. ADJUSTING THE HANDLE POSITION
The handle of car seat can adjust to di erence position. Method as below:
1. Press the handle release button on the handle at same time by both hand .
2. Now toward the arrow direction push backward and forward can adjust the position. Upright position: for transport the baby.
3.Then Release the button when the handle is at the right position. The function of the position as shows. Flat position: for storage
4. Push backward and forward again to con rm the seat is locked rmly. Surport position:for putting your child in or out the seat.
V. CROTCH BELT ADJUSTMENT
The crotch belt is position at the inner slot. Once you feel that the crotch belt is too tight for your child. Please adjust as follow:
1. Pull up the cover at the front of your seat. 2,3. Lift the metal part and through into the outer slot . 4,5.Then pull out at under side then
insert into inner slot. 6. Now through the metal part into the other slot at the top surface of the seat. 7.Throuth the other slot again. 8.
Flat the metal part to nish.
VI. ADJUST THE HEIGHT OF SHOULDER BELT.
This child seat's harness have 2 height position.The top of the shoulder belt must be parallel or a little higher than the child's
shoulers.That can provide the e ective protect for your child at collision. Follow the step as bellow.
1. Relax the harness before adjust the height: One hand press down the center adjuster button at the same time the other hand hold the
shoulder belt and pull back.
2. Press on the release button and separate the buckle tongue.
3. Insert the both tonge through the slots.
4. At the rear side insert the both tongue into other slots.
5,6. Then combi the two tonge and insert into the buckle housing again to nish the adjustement.
VII. SEAT SELECTION AND ADJUSTMENT
1. Adjusting the car seat: Put the car seat on the vehicle seat , and thechil face toward to the rear of veihcle driving direction. Ensures that
the bottom surface of the seat is at to the vehcle seat suface and the front of car seat just touch against veihcle backrest surface.
Otherwise is not OK (Figure1).
2. Seat installation: The child restraint system car seat can be installed in vehicles on any seat suitable for use in the listed vehicles tted
with 3 point with retractor safety-belts, approved to ECE Regulation No. 16 or other equivalent standards.. (Figure 2).
We suggest always to install this child seat atthe rear seat of the vehicle.This will be more safety for your child.
ENGLISH