Time Setting; Troubleshooting; Cleaning And Maintenance - Bresser 8020215 Instruction Manual

TIME SETTING

NOTE!
After the clock received the DCF time signal the time will
be set according to the Central European time (CET).
Summer and winter time change (and reverse) is also
set automatically.
Automatic time setting via DCF time signal
After inserting the battery the time will be set auto-
matically via DCF signal. This process may take a few
minutes. During this process the clock hands will turn
several times with interruption until they will display the
right time.
Initiate to receive the DCF time signal manually
NOTE!
Use this function when e.g. automatic summer/winter
time change does not work or the wall clock temporarely
receives no time signal.
1. Press and hold the REC button (9) for 3 seconds to
start manual search for the DCF signal.
2. The clock hands will move to their start position
(12:00 a.m.) and a the wall clock then tries to receive
the signal.
3. Wait approx. 2-5 minutes until the current time will
be displayed.
Manual time setting
NOTE!
It is necessary to set the time manually in places where
no radio signal is received.
1. Press and hold the M.SET button (10) for approx. 3
seconds.
2. When the minutes hand starts moving you can the set
the time manually:
• Press the M.SET button shortly to set the time in
minutes steps.
• Press and hold the M.SET button to set the time con-
tinously.
3. Release M.SET button to stop manual setting and
save the time automatically and exit manual time set-
ting mode.
RESETTING THE 5-SECOND INTERVAL
The 5-second interval can be reset by briefly pressing
the key (12). This allows you to synchronise the display
of the 5-second interval with the current time. To do this,
check the time at e.g. www.timeanddate.com and press
the button (12) when the seconds show 00.
MOUNTING/POSITIONING
NOTE!
Make sure you have mounted the device in a safe way.
Otherwise the device may fall down and heavy damages
can occur for which the manufacturer is not liable.
The wall clock can be mounted on walls with the wall
mount (6). The recommended hanging height is 2 me-
tres. The detection range of the motion sensor is 125°.
TEMPERATURE DISPLAY / MOTION SENSOR
At the bottom of the wall clock is the motion sensor
for the temperature display (5). The motion sensor has
a range of 2 metres. The temperature is only displayed
when the motion sensor is triggered. The Temperature
measurement works manually. It may take a few min-
utes until the value that is currently measured will be
displayed.

TROUBLESHOOTING

Transmission collision
Signals from other household devices, such as door
bells, home security systems and entry controls, may in-
terfere with those of this product and cause temporarily
reception failure. This is normal and does not affect the
general performance of the product. The transmission
of the radio signal will resume once the interference re-
cedes.
Other malfunctions
If there is no response from the wall clock by keystrokes
or if any other malfunctions occur perform the following
steps.
NOTE!
With this procedure all received data will be deleted.
1. Press RESET button (8) with a pointed instrument
(e.g. pen).
2. The clock hands will move to their start position
(12:00 a.m.) and the wall clock then tries to receive
the signal.
3. Wait approx. 2-5 minutes until the current time will
be displayed.

CLEANING AND MAINTENANCE

Before cleaning the device, disconnect it from the power
supply (remove batteries)!
Only use a dry cloth to clean the exterior of the device.
To avoid damaging the electronics, do not use any clean-
ing fluid.
DE
EN
FR
IT
ES
7