Using Instructions; Cleaning And Maintenance - Warmtech CG3001 Original Instructions Manual

6.

USING INSTRUCTIONS

6.1 Position the fan heater so that it stands upright on a firm surface and at a safe distance from wet
environments and flammable objects.
6.2 Connect the fan heater to the mains.
6.3 Set the thermostat knob to the MAX and let the heater operate with full power.
6.4 The fan heater will switch on when the heating selector is set to one of the power settings.
6.5 Once the room reaches the required temperature, heating element will stop working but fan also
working .Once the temperature decreased, the heating element will be working. The fan heater now
starts and stops automatically and thus keeps the room temperature constant.
6.6 Before switch off the heater, please turn the thermostat to MIN position and turn the switch to fan
position, let the appliance cool down for two minutes then turn off the heater and pull out the plug.
6.7 Before off heater , please turn the thermostat to OFF position and turn the heating knob to Fan or
off , let the appliance cool down for two minutes .
6.8 Time-delay thermostat cut-off , if you forgot to turn the thermostat to OFF position before off heater
, Thermostat cut-off and Fan will be working when the temperature of front grill of heater is near 45°C.
When temperature reduced to about 40° C The thermost at cut-off and fan will stoped working itself. It's
will cool heater .
6.9 This series heater can adjusted angle about 20 according to you requirement by screw on two
°
side panel.
6.10 After using , turn off the heater firstly, pull out the plug.
7.

CLEANING AND MAINTENANCE

7.1 Before cleaning the appliance,disconnect it from the socket and let it cool down. The enclosure is
easily to get dirty, wipe it often with soft sponge. For every dirty parts, wipe with a sponge dipped in
<50° C water and mild detergent,then dry the heater enclosure with clean cloth. Be careful not to let the
water enter the appliance inner. Don't splash water onto the heater,never use solvent like gasoline etc.
to clean the heater,in order to protect the enclosure.
7.2 Clean the cord and plug,dry and pack it in a plastic bag.
7.3 When you store the heater, let it cool down first, keep it dry. Then cover it with a plastic bag, put in
a packing box and store it in a dry, ventilated place.