S&P RESPIRO Series Manual page 43

INSTRUCTIONS FOR CORRECT OPERATION
RESPIRO 100/RESPIRO 150
Speed selection (1/2)
On/off (0/1)
1. Turn-on
Once the product has been installed by qualifi ed staff, turn it on by actuating the "0/1" switch on the side of the main unit.
Make sure that the indicator light is on.
Once the damper is open the product starts working normally with the 70 seconds air intake and 70 seconds air extraction
cycle.
2. Speed selection
It is possible to increase or decrease the air exchange fl ow by means of the "1/2" switch on the side of the product.
Select speed 1 for a more silent air exchange.
Select speed 2 for a faster air exchange.
3. Wall commands
If during the installation carried out by qualifi ed staff, the "on/off" and "speed selection" controls are remounted on the
wall, make sure that the controls on the product are both positioned at "1".
The instructions for the commands remounted on the wall are the same as those of the aforementioned product.
4. Turn-off
Position the "0/1" switch on the side of the unit to "0".
If the controls have been carried to the wall, position the wall-mounted switch to "0". Keep the "on/off" switch on the side
of the unit on "1".
RESPIRO 100 RD/RESPIRO 150 RD
On/off (0/1)
If you only have one unit, access the product using the "0/1" switch and then wait for the correct confi guration. After the red
and white confi guration pulse, the machine will start in the "AUTOMATIC" function.
If you have more than one unit, see the paragraph "MASTER-SLAVE PRODUCTS CONFIGURATION".
Attention: When fi rst turned on the product executes the auto-calibration of the hygrostat. It is possible that during this
phase the "EXTRACTION" function will be activated to bring the room's humidity below the level required for this auto-ca-
libration.
43