Advanced Settings Detail - SmartVent Positive2 User Manual

Advanced Settings Detail

Index Description
000 TSC Firmware Version
001 Ceiling Controller Hardware Version
002 Ceiling Controller Firmware Version
003 Ceiling Controller Macro Version
004 Maximum Roof Temperature
005 Minimum Roof Temperature
006 Set Temperature Threshold
007 Set Temperature Differential Threshold
008 Heat Transfer High Threshold
009 Heat Transfer Medium Threshold
010 Filter Used Percentage / Reset
011 Ceiling Temperature Calibration
012 Room Temperature Calibration
013 Maximum Backlight Brightness
014 Minimum Backlight Brightness
015 Boost Timer
016 Filter Reset
017 Reserved
Notes:
*1. If RECYCLE
reading goes above the maximum temperature setting or goes below the
minimum temperature setting, then recycle mode will turn on.
*2. If your incoming air or room temperature readings are inaccurate, use these
settings to calibrate them.
*3. Change setting value to 10 and press SELECT
mode is enabled and the incoming air temperature sensor
MENU
Range Default Note
N/A N/A
N/A N/A
N/A N/A
N/A N/A
20°C - 50°C 30°C
0°C - 20°C 5°C
0°C - 5°C 1°C
0°C - 20°C 5°C
0°C - 15°C 5°C
0°C - 15°C 2°C
N/A N/A
-5°C - 5°C 0°C
-5°C - 5°C 0°C
0-100% 80%
0-100% 10%
0 min – 60 min 20 min
0 - 100 0
N/A N/A
to reset the filter timer.
*1
*1
*2
*2
*3
27