Operation - Warmtech PR1501 Original Instructions Manual

the wall. Aim two rubber pads on the back of heater with screws.
Third,find two holes locations on the handle at the rear of the heater and fix
them to the hooks on the wall.Pull the heater rightward to make the hooks
tally with the holes locations.
NOTE:
If wall mount method is adopted, installation of truckles is not allowed.
The mounting location shall be 15cm above the floor and 50cm beneath
the ceiling or more. You may refer to the following figure.
V. OPERATION
1) Room temperature can be adjusted using the thermostat. Simply turn the
thermostat knob clockwise, to increase the heater, and anti-clockwise to decrease
the temperature, until you reach the desired temperature.
2) Switch the heater to one of the following power settings.
A) PR1501 : Push switch one (I) for 750W
B) PR2001 : Push switch one (I) for 1000W
3) The power switch lights up when activated.
4) Turning the thermostat control clockwise will increase the "set" temperature.
5) Turning the thermostat anti-clockwise will decrease the "set" temperature.
6) Do not cover the heater at any time during operation. There is a risk of fire if the
heater is covered.
7) Once you have finished using your heater, turn the power switches off, and the
thermostat control switch to the "Low" positions, and unplug from the mains supply.
Push switch two (II) for 1500W
Push switch two (II) for 2000W