LOGO! Expansion Module
CM LON
2.2 Wiring the CM LON
To wire the CM LON, use a screwdriver with 3 mm wide
blade.
- You do not need to use wire end ferrules when clamping
the wires.
After the installation, the terminals must be covered. To
protect personnel against unintentional contact with the
portions of the CM LON that are conducting electricity, the
appropriate national and local standards must be observed.
The CM LON is a double-insulated switching device.
A protective grounding conductor is not necessary.
CM LON
J31069-D1263-U002-A2-7618
NOTE
9