Realignment; Modes; How To Enter Each Mode - Kenwood NX-3220 K Service Manual

2.2

REALIGNMENT

2.2.1 Modes

User mode
Panel tuning mode
Panel test mode
PC mode Data programming mode
PC test mode
Firmware programming mode
Clone mode
Front panel programming mode*1
Transceiver information mode
*1:In order to use the Front panel programming mode, it is
necessary to purchase the "Front panel program" feature
option.
Mode
User mode For normal use.
Panel test mode Used by the dealer to check the
fundamental characteristics.
Panel tuning mode Used by the dealer to tune the transceiver.
PC mode Used for communication between the
transceiver and PC.
Data programming Used to read and write frequency data and
mode other features to and from the transceiver.
PC test mode Used to check the transceiver using the
PC. This feature is included in the FPU.
Firmware Used when changing the main program of
programming the flash memory.
mode
Clone mode Used to transfer programming data from
one transceiver to another.
Front panel Frequency, signaling and features write to
programming the transceiver.
mode
Transceiver Used to confirm the transceiver firmware
information mode version, Encryption Library version.
1-8 (No.RA053<Rev.001>)
PC tuning mode
Function

2.2.2 How to Enter Each Mode

Mode
User mode Power ON
Panel test mode*2,*3 • [
• [
Select the "Panel Test" using the [] /
[] button.
Press the [
PC mode Received commands from PC
Panel tuning mode *2 [Panel test mode] + [
Firmware programming • [AUX (Orange)] + Power ON
mode*3
• [
Select the "Firmware Prog" using the
[] / [] button.
Press the [
• If Write is performed by KFL,
Firmware programming mode will
start automatically.
Clone mode*2,*3 • [
• [
Select the "Clone" using the [] / []
button.
Press the [
Front panel • Press the PF button to which Front
programming panel programming mode is set
mode*2,*3 during the user mode.
• Press the [
Menu mode.
Select the any icon assigned the Front
panel programming mode using the
[] / [] button.
Press [
Select the "Panel Program" using the
[] / [] button.
Press the [
Transceiver • [Side 1] + Power ON
information mode*2,*3
• [
Select the "Transceiver Info" using the
[] / [] button.
Press the [
*2 K2, K3, E and E2 types only.
*3 There is the two or three as how to enter.
2.2.3 Panel Test Mode (K2, K3, E and E2 types only)
Setting method refer to ADJUSTMENT.
2.2.4 Panel Tuning Mode (K2, K3, E and E2 types only)
Setting method refer to ADJUSTMENT.
Operation
] + Power ON
] + Power ON *3
] button.
]
] + Power ON *2
] button.
] + Power ON
] + Power ON
] button.
] button and enter the
] button.
] button.
] + Power ON
] button.