Removing The Terminal Block (With Packing); Removing The Stopper Of The Selector Circle Nut; Removing The Lcd From The Display Unit; Insert Direction For The Fpc - Kenwood NX-3220 K Service Manual

3.2.9 Removing the TERMINAL BLOCK (with PACKING)

(1) Remove the screw. <1>
(2) Remove the TERMINAL BLOCK (with PACKING). <2>
TERMINAL BLOCK
3.2.10 Removing the stopper of the selector circle nut and
volume circle nut
(1) Remove the stopper using a pair of tweezers. <1>
(2) Remove the circular nut <2> using the nut wrench (W05-
1123-00).
<1>
<2>
Stopper
Circular nut <2>
<1>
Note:
When reassembling, make sure the stopper and the
circular nut are engaged.

3.2.11 Removing the LCD from the Display unit

(1) Remove the LCD FPC from the connector. <1>
(2) Remove the Display ASSY fixed with two tabs.<2>
(3) Remove the shielding case fixed with four tabs.<3>
(4) Take the LCD out of the case.
LCD FPC
<2>tab
<3>tab
<2>tab
3.2.12 Forming the FPC (for connection of DISPLAY UNIT
and TX-RX UNIT)
Bend the FPC twice along the mark. <1> <2>
Mark
<1>
<2>
Mark
3.2.13 Insert direction for the FPC (for connection of
DISPLAY UNIT and TX-RX UNIT)
Insert the FPC with the electrode surface downward.
<3>tab
<3>tab
<3>tab
Case
Display unit
(No.RA053<Rev.001>)1-29
LCD