Removing The Mechanical Stopper (Without Lcd Models); Removing The Front Case From The Chassis; Remove The Holder Assy From The Chassis; Removing The Display Unit From The Chassis - Kenwood NX-3220 K Service Manual

3.2.3 Removing the mechanical stopper (without LCD
models only)
(1) Pick up and lift the tab of a mechanical stopper using a pair
of tweezers.
Note:
Take care not to damage the packing.
(2) Remove the mechanical stopper. <1>
<1> <1>

3.2.4 Removing the front case from the chassis

(1) Remove the rear panel with a flat-head screwdriver.
Insert the screwdriver between the rear panel (right side)
and the chassis, push it in the direction of the arrow
<1>,and remove the right side of the rear panel. Repeat the
above action for the left side of the rear panel <2>.
Rear panel
(2) Remove the two screws <3>.
(3) Peel off the void seal.
(4) Lift the base of the chassis and remove the chassis from
Mechanical stopper

3.2.5 Remove the holder ASSY from the chassis

(1) Remove the four tabs on the holder ASSY from the
(2) Lift up the holder ASSY, then remove the speaker lead wire
<1>
<1>

3.2.6 Removing the Display unit from the chassis

(1) Remove the five screws <1>.
<2>
(2) While lifting the Display unit, remove the FPC from the
the front case. <4>
Note:
• Once the void seal is peeled off, it cannot be used
again.
• When the chassis cannot be removed from the front
case, remove by pushing in the button top with the
finger.
• Regarding VOID, confirm the service policy of the NX-
3220 and NX-3320 to KENWOOD (or authorized
distributor).
VOID seal
chassis.<1>
from the connector (CN602).
<1>
<1>
<1>
connector (CN202) of the Display unit.
<1>
<1>
<1>
<1>
<1> Display unit
<3>
<3>
<4>
Speaker lead wire from
the holder ASSY
CN602 CN602
FPC
TX-RX unit
-
(No.RA053<Rev.001>)1-27