Belimo Clear Edge EAP005 Installation Instructions

INSTALLATION INSTRUCTIONS
Belimo Clear Edge Device
INSTALLATION / MOUNTING
Front View
Side View
Rear View
Wall Mounted Option
Step 1. Mark and prep holes on surface for mounting
Step 2. Attach mounting bracket to chassis
Step 3. Fasten system to surface
DIN Rail Option
Step 1. Attach DIN rail mounting brackets to chassis
Step 2. Clip system to DIN rail
Power Connection
Connect supplied 12 VDC power adapter to approved power source.
GENERAL WARNINGS
1. Do not open or modify the device. The device uses components
that comply with FCC and CE regulations. Modification of the
device will void these certifications.
2. Install the device securely. Be careful handling the device to
prevent injury and do not drop.
3. Wall or ceiling mounting device requires use of a mounting plate or
bracket. Plate or bracket must be of metal construction and have a
minimum thickness of 1mm.
4. Use M3x0.5mm Flat Head screws to attach mounting plate or
mounting brackets to threaded holes on bottom of chassis. Screws
should be minimum length of 4mm. Add 1mm of screw length
for every mm of additional thickness of plate or bracket beyond
1.5mm.
5. Operational temperature must be between 32°F-122°F
[0°C-50°C] with a non-condensing relative humidity of 10-90%.
6. The device can be stored at temperatures between 32°F-122°F
[0°C-60°C].
7. Keep the device away from liquids and flammable materials.
8. Do not clean the device with liquids. The chassis can be cleaned
with a cloth.
9. Allow at least 2 inches of space around all sides of the device for
proper cooling.