McCulloch ROB S600 Operator's Manual page 34

Message Cause
Empty battery
The product cannot find the charging station.
The battery is expired.
The antenna of the charging station is defec-
tive.
The charging plates on the product or con-
tact plates on the charging station are defec-
tive because of corrosion.
Wrong PIN code
Incorrect PIN code has been entered. 5 tries
are permitted to enter the correct PIN code,
and then the keypad is blocked for a period
of time.
No drive
The product has got caught in something and
has been slipping.
The work area includes a steep slope.
The guide wire is not put diagonally in the
slope.
Wheel motor overloa-
Grass or other object around the drive wheel. Remove grass or object from the drive
ded, left/right
Collision sensor The product body cannot move freely around
problem, front/rear
its chassis.
Alarm! Mower switch-
The alarm has started because the product
ed off
had been switched off.
Alarm! Mower stop-
The alarm has started because the product
ped has been stopped.
Alarm! Mower lifted
The alarm has started because the product
has been lifted.
Alarm! Mower tilted The alarm has started because the product
has been tilted.
34 - Troubleshooting
Action
Change the position of the guide wire. Refer
To install the guide wire on page 18 .
to
Replace the battery. Refer to
page 31 .
Do a check if the indicator lamp in the charg-
ing station flashes red. Refer to
lamp in the charging station on page 39 .
Clean the charging and contact plates using
a fine grade emery cloth. If the problem stays
speak to your authorized service technician.
Enter the correct PIN code. Speak to your
McCulloch customer service if you forget the
PIN code.
Free the product and correct the cause of
problem. If it is because of wet grass, wait
until the lawn is dry before you use the prod-
uct.
Steep slopes must be isolated. Refer to
examine where to put the boundary wire on
page 13 .
Make sure that the guide wire is installed di-
agonally across the slope. Refer to
ine where to put the guide wire on page 16 .
wheel.
Make sure that the product body can move
freely around its chassis. If the problem stays
speak to your authorized service technician.
Adjust the security level in the
Security level on page 22 .
menu. Refer to
1411 - 007 - 23.09.2020
Battery on
Indicator
To
To exam-
Security